home | favorite   
facebook youtube alibaba
HOME ABOUT PRODUCT NEWS GLORIES JOB MESSAGE CONTACT
  中文 English Spanish
 
 
  ATS
  STFD AVR
  Cater Replacement
  Mecc Alte Replacement
  Marathon Replacement
  Marelli Replacement
  General AVR
  Brush AVR
  Kutai/Basler Replacement
  charger
  Governor
  Deep Sea Controller Replacement
  Generator Other Parts
  Siemens Generator Series
  Solenoid
 
 
View
Name:

DSE5510

Features

FEATURES
•  Electronic engine capability
•  RS232 or RS485 remote communications
•  Modbus RTU
•  Pin number protected front panel programming
•  Engine exercise timer
•  Back-lit LCD 4-line text display
•  Multiple display languages
•  Voltage measurement
•  Configurable inputs (9)
•  Configurable outputs (5)
•  Automatic start
•  Manual start
•  Audible alarm
•  LED indicators
•  Built-in governor and AVR control
•  Engine history event log
•  Engine protection
•  Fault condition notification to a designated PC
•  Front panel mounting
•  PC configuration
•  Bus failure detection
•  Configurable alarm timers
•  Configurable start & stop timers
•  Automatic load transfer
•  SMS alert messaging
•  Front panel mounting
•  Remote monitoring
•  Magnetic pick-up

LOAD SHARE FEATURES
•  ROCOF & vector shift
•  Automatic starting & stopping of generator on load demand
•  Automatic hours run balancing of generator sets
•  Dead bus sensing
•  Module has the ability to interface with existing load share lines
•  Direct communication from the module to the governor and AVR
•  Link up to 16 generators
•  Volts & frequency matching
•  KW and Kvar load sharing with multiple generators

BENEFITS
•  Sends SMS messages to engineers to notify specific engine problems (GSM Modem and
SIM card required)
•  On-site and remote (modem required) module configuration
•  In-built engine diagnostics removes the requirement for service equipment
•  Full engine protection & instrumentation without the need for additional senders
(Electronic engines only)
•  Remote monitoring of the module using comprehensive DSE PC software
•  License free PC software

Technical parameters

DC SUPPLY
8 V to 35 V Continuous

CRANKING DROPOUTS
Able to survive 0 V for 50 mS, providing supply was at least 10 V before dropout and

supply recovers to 5 V. This is achieved without the need for internal batteries

MAXIMUM STANDBY CURRENT
375 mA at 12 V, 200 mA at 24 V

MAXIMUM OPERATING CURRENT
460 mA at 12 V, 245 mA at 24 V

ALTERNATOR INPUT RANGE
15(L-N) to 333V AC (L-N) absolute maximum

ALTERNATOR INPUT FREQUENCY
50Hz-60Hz at rated engine speed (Minimum:15V AC L-N)

MAGNETIC PICK-UP VOLTAGE RANGE
+/- 0.5 V to 70 V Peak

MAGNETIC INPUT FREQUENCY
10,000 Hz (max)

START RELAY OUTPUT
16A DC at supply voltage

FUEL RELAY OUTPUT
16A DC at supply voltage

AUXILIARY RELAY OUTPUTS
Three outputs 5A DC at supply voltage
Two outputs volt free 8A at 250V AC

DIMENSIONS
240 mm x 172 mm x 57 mm
9.4” x 6.8” x 2.2”

PANEL CUT-OUT
220 mm x 160 mm
8.7” x 6.3”

CHARGE FAIL/EXCITATION RANGE
0V to 35V

BUILT IN GOVERNOR CONTROL
Fully Isolatd
Minimum Load Impedence:1000(Ohms)
Gain Vlts 0V - 10V DC
Offset Volts +/- 10V DC

Back >>
 Copy right  © Fujian Permanent Electron Co.,Ltd.  Technical Supportwww.nd-china.com
facebook youtube alibaba

Address:No.C-13-1 Tiehu Mechanical & Electrical Industrial Zone, Chengyan Town, Fuan,Ningde, Fujian, China
Tel:86-593-6050668  Fax:86-593-6116388   E-mail: avr@permanent.cc; avr@fjzhdz.com